Are you complaining that your screw conveyor always have problems and you feel you bought a bad quality conveyor? After reading this article you will change your opinion.
Based our investigation, we find that many users operate the screw conveyor in the way. It will not only result in conveyor damage, but also harm to the operating personnel. Please avoid the following wrong operating methods in order to hope utilize the screw conveyor reasonably.
1.Open the upper cover plate during conveyor running.
Users always open the upper cover in order to observe running situation easily, however, this behavior is forbidden. During running ,if sundries fall into conveyor, the conveyor will break down, such as screw blade deformation, shaft cracking, casing damage, etc.
2.Do not clean the residual material timely after using conveyor .
If the residual material is sticky and corrosive, the blade and shaft will be corroded which will lead to a shorter service life.
3.Motor is overloaded heavily.
It can make motor temperature become too high even it will lead to motor overburning. Please control the feeding flow strictly, vibrating feeder will be a good choice.
4.Do not add lubricating oil for bearing.
The dust can make the lubricating oil become viscous, thus it will influence shaft rotating, so please add oil regularly.
5.The temperature of reducer is too high.
The reason is reducer lack of lubricating oil, please check the oil amount before conveyor running.
6.After shutting down the conveyor, the shaft is forced to stop rotating.
This behavior is very dangerous, it will harm the screw blade, shaft and motor. We should stop the screw conveyor naturally.
Based our investigation, we find that many users operate the screw conveyor in the way. It will not only result in conveyor damage, but also harm to the operating personnel. Please avoid the following wrong operating methods in order to hope utilize the screw conveyor reasonably.
1.Open the upper cover plate during conveyor running.
Users always open the upper cover in order to observe running situation easily, however, this behavior is forbidden. During running ,if sundries fall into conveyor, the conveyor will break down, such as screw blade deformation, shaft cracking, casing damage, etc.
2.Do not clean the residual material timely after using conveyor .
If the residual material is sticky and corrosive, the blade and shaft will be corroded which will lead to a shorter service life.
3.Motor is overloaded heavily.
It can make motor temperature become too high even it will lead to motor overburning. Please control the feeding flow strictly, vibrating feeder will be a good choice.
4.Do not add lubricating oil for bearing.
The dust can make the lubricating oil become viscous, thus it will influence shaft rotating, so please add oil regularly.
5.The temperature of reducer is too high.
The reason is reducer lack of lubricating oil, please check the oil amount before conveyor running.
6.After shutting down the conveyor, the shaft is forced to stop rotating.
This behavior is very dangerous, it will harm the screw blade, shaft and motor. We should stop the screw conveyor naturally.
.jpg)
No comments:
Post a Comment